Radium Fuel Hanger for Nissan R35 GTR No Pump 20-0572

OVERVIEW
The Radium Engineering fuel hanger completely replaces the factory in-tank fuel pump unit in the R35 GT-R and permits up to three 39mm diameter aftermarket pumps (brushed or brushless) to supply fuel to the engine. No permanent vehicle modifications are required for installation. The pumps are housed in an aluminum collector box that is kept full during operation. This ensures that fuel starvation does not occur, even during aggressive driving. The fuel pump outlet port is -10AN ORB female threaded, while the return port is -8AN ORB female threaded. The system is compatible with alternative fuels such as methanol, ethanol, E85, etc. Radium Engineering recommends reviewing the installation instructions (link above) before purchasing.

PREVENTING FUEL STARVATION
The GT-R saddle bag style fuel tank uses two OEM venturi jet pumps. They supply fuel from both sides of the tank to the OEM pump bucket and are driven by fuel returning from the regulator. When the fuel pumps are upgraded, these venturi jet pumps become a restriction in the return line, resulting in elevated fuel pressures and unreliable regulator performance. By reconfiguring the venturi jet pump plumbing, Radium Engineering has kept their functions without impacting the returning fuel from the regulator. This allows the pumps to be upgraded without fuel pressure concerns.
NOTES: 
1. Depending on fuel pressure, the venturi jet pumps will consume 15-45 LPH. Take this fuel loss into consideration when sizing the fuel pumps.
2. If it is important for fuel pressure to hold steady after the engine is shut down, install a check valve somewhere in the fuel system.

PLUMBING
To clear the OEM fuel pump cover plate, the standard fuel hanger kit includes low profile swiveling adapters that convert to 6AN male, along with short PTFE hoses and adapters for easy connection to the OEM fuel piping. Other adapter fittings are available and are sold separately.

ELECTRICAL
The Radium fuel pump hanger features custom designed stainless electrical studs that easily handle the high current demand that multi-pin bulkhead connectors lack. These serviceable connections are hermetically sealed and impervious to all standard and exotic fuels. Non conductive anodized aluminum acorn nuts are provided to prevent any accidental short circuiting. Electrical hardware is included for the fuel pump(s) and OEM sensors. Furthermore, the in-tank wiring is insulated with high quality chemically resistant ETFE. The factory temperature sensor and fuel level sender is reused.

PUMP COMPATIBILITY
Traditional Brushed Fuel Pumps
Radium Engineering offers this fuel pump hanger system pre-assembled with dual or triple AEM 50-1200 or Walbro GSS342 (255lph) pumps. 
It is also available with "no pumps included" which requires the installer to provide their own pumps and perform final assembly.
Other makes/models of pumps can be used assuming they have the same fitment, form factor, and electrical connection as the aforementioned Walbro/AEM pumps.

NOTE: The larger Walbro E85 pumps (F90000267/274/285/295) are not compatible with this product.

Brushless Fuel Pump Systems
For vehicles with high fuel demands, a brushless fuel pump system may be a good option. This Radium in-tank hanger system is compatible with up to three Ti Automotive E5LM brushless fuel pumps.
A brushless fuel pump requires a separate stand-alone controller. At the release of this product, there are two options for E5LM pump/controller kits: 
-Injector Dynamics ID-BPC-1100
-Ti Automotive BKS1000 (shown below)